Enable or disable Epiphan Edge access

Epiphan Edge is where you go to remotely manage and control your Pearl Nano. Access is enabled on Pearl Nano by default. All you need to do is pair the Pearl Nano to your free Epiphan Edge account for access to your device over the Internet. You can disable Epiphan Edge access on your Pearl Nano from the device screen or using the Admin panel and enable it again later. Access is enabled by default.

Important considerations

  • Unpair the Pearl device from Epiphan Edge before disabling Epiphan Cloud access on the Pearl device using the Admin panel.
  • If you disable Epiphan Edge access while the Pearl device is paired, the device instance in Epiphan Edge goes permanently offline. For more information, see Pair and unpair from Epiphan Edge.

Enable or disable Epiphan Edge access using the Admin panel

  1. Log in as admin, see Connect to the Admin panel.
  2. From the Configuration menu, click Maintenance. The Maintenance page opens.
  3. Uncheck Enable Epiphan Edge to disable the feature or leave it checked to allow the Pearl device to access Epiphan Edge. Click Apply to save your changes.

    4.  

Enable or disable Epiphan Edge access using the front screen menu on Pearl Nano

  1. Press the left arrow key repeatedly on the control interface until the Menu screen displays.

  2. Use the arrow and check mark keys to select System. Then from the System screen, select Settings to open the Settings screen.

    3.  

  3. From the Settings screen, select Epiphan Edge to open the Epiphan Edge screen.

    4.  

  4. Highlight Enable Epiphan Edge and press the check mark key to toggle the switch on or off.